|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
OptoTest OP750 Multi Channel Light Source
The OP750 multichannel source can be configured for a mix of up to 24 individual or switched LED or laser sources. A single wavelength LED sources feature and internal large core fiber to guarantee an overfill condition into 62.5/125 or 50/125 multimode fiber available for the wavelength 850nm and 1300nm. The single wavelength sources for 1310nm and 1550nm are terminated with standard 9/125 fiber. A dual wavelength option, 1310nm and 1550nm into a single port is available as well (12 channel version only). Key Features :
OptoTest OP710 Multi Channel Power Meter
The OP710 offers an economical approach for optical power measurement applications where multiple channels are needed.Unlike other systems this instrument is built up with individual power meters allowing for unparalleled simultaneous data acquisition over all channels.
The OP710 is available starting at 8 up to 24 channels and can be configured for a variety of detector and connector interfaces. With the rack mount option multiple instruments can be combined and configured for even higher channel count.
Key Features :
All specifications are valid within temperature range of 18º C to 24ºC unless otherwise noted. * NIST traceable calibration at -10dBm power level. ** Linearity for loss<5dB and absolute power within 0dBm..-65dBm *** Linearity for +3dBm to 0dBm, and -65dBm to 72dBm Applications : Multifiber Test Setup
The OP930 is based on a high resolution reflectometer with a dynamic range from 10dB to 72dB. A reflectometer measures the reflections of components spatially right at the connector under test there is no mandrel wrap or matching gel needed at the far end of the cable to be measured. The internal switch of the OP930 can be factory configured from 2 channel to 24 channels. For a higher channel count a single channel OP930 is connected to an external switch of any size. All those configurations are support by OPL-MAX and OPL-LOG.
The Return Loss can be measured at two wavelength concurrently saving measurement time in the production environment.The OP930 supports a CW source mode. For the Return Loss measurement the laser sources are pulsed in the nanosecond region. For certain measurements a continuous modulated (CW) light signal is a required. The OP710 OPM is built up with individual power meters, one per optical port. This allows for simultaneous data acquisition over all channels which reduces the process time The optical power meter offers a wide measurement range from +10dbm to -80dBm with 0.001dB resolution and tight linearity specification. Depending on the detector it typically covers the wavelength range of 840nm to 1700nm.
To measure power levels on ribbon fibers terminated with any of the MT connectors styles following large area detector options are supported: either a 5mm wide (for singlemode), a 10mm wide for
All OptoTest instruments are equipped with the USB 1.1/2.0 compatible data port and support data rates up to0.2 MB/s with the appropriate drivers
|
Quick Links
Insertion and Return Loss Test Sets
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Fully
automated, concurrent dual wavelength IL and RL.
